You will see the completed RAID Volume.Select the stripe size, and if desired, Capacity.For both Disks, click the pull-down menu and select X.Name the volume and set the RAID Level.If you do not see two discs in the Non-RAID Physical Disks section, turn off the NUC, open the chassis and check the connections for both discs. Navigate to Advanced > Add-in config > Intel(R) Rapid Storage Technology, then select Create RAID Volume.Press F10 to save the changes, then select OK and the system will reboot.Change, Map this Root Port under VMD, to Enabled.Set, Enable VMD controller (Enable for RAID and Optane Memory), to Enabled.Press F2 during boot to enter the BIOS setup.Ĭreating a new RAID, SATA, or PCIe, will format your discs and erase all content.Īptio® V UEFI Firmware Core (BIOS) for 11th Generation Intel® NUC SATA (AHCI) RAID See the instructions in the Windows 7 UEFI Image Creation guide. If you're using Windows 7*, the Windows 7 ISO image should be written to your USB flash drive via UEFI.Both drives need to be either AHCI (SATA) or NVMe* (PCIe*).For example, if your two drives are 256 GB and 128 GB, the largest size the RAID can be is 256 GB (128 GB × 2). The capacities of the drives don't have to be the same, but the RAID volume will only be two times the size of the smallest capacity drive.Two M.2 NVMe SSDs (supported by NUC11PHKi7C, NUC9iQNX, NUC9VQNX, NUC8i7HNK, NUC8i7HVK, and NUC6i7KYK only).One 2.5" SATA drive and one M.2 SATA drive.Drives (one of the following combinations):.Windows 7*, Windows 8.1*, or Windows® 10 64-bit* Installer.The latest Intel® Rapid Storage Technology Driver Installation Software with Intel® Optane™ Memory or Intel® Rapid Storage Technology (Intel® RST) User Interface and Driver, available on Intel® Download Center.If you want to configure Intel® Optane™ Technology on supported Intel NUCs, see Installing Intel® Optane™ Memory on Intel® NUC Kits. This guide shows the process for setting up software RAID using the SATA (AHCI) method and the PCIe (NVMe) method and provides resources to setup RAID in Linux*. You can use this technology for the purpose of redundancy, performance, or both.Īll Intel® NUC products that have multiple drives allow for the creation of a software RAID. Software RAID technology allows the combination of multiple physical disks into one logical unit, or disk.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |